V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Constant Velocity Joint Boot: Procedures
Replacing boots on left/right drive shafts
Special tools: 951 2619, 999 5118, 999 5476, 999 5519
Removing and installing drive shafts
To remove/install drive shaft, see Axle Shaft Assembly; Service and Repair. See: Service and Repair/Procedures
The following method is the same for the left and right drive shafts.
Replacing outer constant velocity joint boot
Introduction
To facilitate the removal of the drive shaft constant velocity joints, grind down a drift as illustrated. Rounding the lower edge (R) means that the drift
will not catch in the drive shaft circlip groove. The sharper angle (approx. 600) means that drift has a greater surface contact with the inner ring.
Removing boot
Remove boot clamps.
Cut boot and remove it from the shaft.
Exposing outer constant velocity joint
