V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Transmission Position Switch/Sensor: Testing and Inspection
Checking and adjusting the gear-shift position sensor
Special tools: 9995475
Preparations
Preparations, removing
Ensure that the gear selector is in N.
Remove:
-
The battery
-
The air cleaner (ACL) housing assembly
-
The transmission cable from the lever
-
The lever.
Checking and adjusting gear-shift position sensor
Check
NOTE! Press the tool down towards the flat surfaces below the thread on the shaft.
Install tool 999 5475 on the gear shift linkage rod. Check that the rod is in the N position (second position after the P position, P-R-N).
The slot on the tool must line up exactly over the marking on the gear-shift position sensor.
Adjustment
