V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Use an ohmmeter to measure the resistance between the transmission connector and the end of the appropriate solenoid cable. Shake the harness
gently during the measurement to identify any possible loose connections. The ohmmeter should read approximately 0 [ohm].
Removing the gear-shift position sensor
Remove:
-
The transmission cable from the lever
-
The lever
-
The nut, the locking washer and the rubber washer for the gear shift linkage rod
-
The dip stick pipe. Lift up the pipe and turn it to one side.
-
The mounting screws for the gear-shift position sensor (two)
Carefully lift the sensor from the gear shift linkage rod.
CAUTION: If the metal tongue on the gear-shift position sensor gets stuck on the transmission cable bracket: Remove the bracket and put it to one
side.
Removing the cable harness
Remove the holder, spacer for the cable harness grommet in the transmission.
Remove the cable harness grommet from the transmission.
Remove the cable harness from the transmission.