V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Ensure that:
-
The bracket for the dip stick pipe has been slackened off.
-
The gear-shift position sensor screws have been slackened off.
Rotate the gear position sensor so that the mark on the sensor is lined up exactly with the slot on the tool.
Tighten the sensor screws.
Tighten to: 25 Nm.
Installation
Installing components
Install:
-
The bracket for the dip stick pipe. Ensure that the O-ring is in position. Tighten the nut Tighten to: 25 Nm.
-
The lever on the gear shift linkage rod. Tighten to: 16Nm.
-
The transmission cable on the lever with a washer and retaining clip. Apply a small amount of grease (P/N 1161241-3) to the lever shaft journal.
Installing engine compartment components
Install:
-
The battery shelf
-
The air cleaner (ACL) housing assembly
-
The battery.
