V40 L4-1.9L Turbo VIN 27 B4204T4 (2003)
Carefully tap the end of the valve stem to ensure that the valve is correctly located in the seat. Use a plastic, aluminum or brass drift to protect the valve
and the surface of the valve lifter.
The sound made by tapping reveals if the valve is correctly seated.
Installing the camshaft and valve lifter
Install both the valve lifters for the inlet valves at cylinder 1.
Check the previously taken notes.
Note! Only install two valve lifters. The valve lifters must be placed at the same cylinder.
Install the intake camshaft. Ensure that the lobes at cylinder 1 point upwards.
Apply a little oil to the cam lobe and the upper side of the valve lifter to facilitate measurement later.
Installing the camshaft press
Install the lower section of camshaft press 999 5765 Holder camshaft See: Tools and Equipment/999 5765 Holder Camshaft at the intake valves for
cylinder 1.
Tighten the tool against the cylinder head. Tighten to 17 Nm.
Turn the camshaft until it stops against the camshaft press.
