V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Install the lift mechanism in the door. Connect the connector.
Note! Apply contact grease P/N 1161427 in the connector.
Note! Install the under side first. Then the top and finally the mechanism.
Install the screws (B and C). Tighten by hand.
Slide the window down until the lugs run over the window rail.
Install the two screws (A). Tighten by hand.
Wind the window up and down a few times. Then close the window.
Check the alignment of the window.
Tighten the screws (B and C). Tighten to 8 Nm.
Wind the window down so that the screws (A) can be tightened. Tighten to 4 Nm.
Wind the window up and down a few times to check the function.
Installing the inner lock mechanism
Install the inner lock mechanism according to The lock unit and handle for the rear side door See: Locks/Door Locks/Door Lock Cylinder/Service and
Repair/The Lock Unit And Handle For The Rear Side Door.
Installing the door insulation
Install:
-
the run-off profile according to Run-off profile See: Front Door/Front Door Panel/Service and Repair/Removal and Replacement/Side Door With
Controls
-
the upper tie strap in the door panel
-
the door panel according to The panel for the rear side door See: Rear Door Panel/Service and Repair/Removal and Replacement.
Clean the window.