V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Remove:
-
the panels over the front mountings on the seat: Pull straight up
-
the panels above the rear mountings for the seat: Pull up and backward
-
the 4 screws for the seat.
Tip the seat back.
Slacken off the screw for the control module.
Remove:
-
the connector (2)
-
the control module (3).
Installing The Control Module
Install:
-
the control module (3)
-
the connector (2).
Tighten the screw for the control module.
Tilt the seat back.
Install:
-
the 4 screws for the seat. Tighten to 40 Nm
-
the panels above the rear mountings for the seat
-
the panels above the front mountings for the seat.
Finishing
Check that no diagnostic trouble codes have been stored during the repair.