V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Carefully lift in the hydraulic modulator
-
Install the 3 rubber dampers and the 2 mounting lugs
-
Install the hydraulic modulator
-
Tighten the 2 nuts. Tighten to 25 Nm (E).
-
Assemble the connector for the control module (D)
-
Install the mounting clamps (B) for the brake pipes. Ensure that the brake pipes are correctly positioned in the rubber holder
-
Install the brake pipes. Tighten to 14 Nm (F)
-
Screw the fluid reservoir (C) for the power steering system into place
-
Install the hose mounting and hoses on the fender liner at the hydraulic modulator (A).
Wash away any spilled brake fluid with warm water and car shampoo.
Bleed the brake system according to Bleeding brake system See: Brake Bleeding/Service and Repair
Checks after finishing work
-
Read off and erase any diagnostic trouble codes (DTCs)
-
Test drive the car according to Test driving See: Testing and Inspection/Initial Inspection and Diagnostic Overview
-
Check whether any diagnostic trouble codes (DTCs) have been stored.
