V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Wheel Speed Sensor: Removal and Replacement
Front Wheel Sensor, Replacement
Front wheel sensor, replacement
Preparations
Ignition off.
Remove the hub cap and the wheel.
Removing front wheel sensor
Note! Carefully clean the sensor and the connector before they are removed.
Remove the mounting bolt and pull out the sensor.
Remove the two brackets from the inside of the wing.
Pull the sensor cable out of the supports.
Partially remove the plastic inner wing.
Disconnect the connector.
Installing front wheel sensor
Clean the sensor seat of dirt and rust so that the sensor is in the correct position relative to the pulse wheel.
Clean dirt from the pulse wheel using compressed air.
Connect the connector and install the two screws to the inside of the wing.
Install the plastic inner wing.
Clean the mounting surfaces so that the sensor can be fitted easily. Lightly grease the sensor.
Install the sensor. Tighten to 25 Nm.
Press the sensor cable into the support.
Install the wheel, see operation Replacing front brake pads See: Disc Brake System/Brake Pad/Service and Repair/Removal and Replacement/Replacing
Front Brake Pads.
Checking correct operation of ABS system
