V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Block the brake caliper against the brake disc. Use special tool 999 5782 Press tool See: Tools and Equipment/999 5782 Press Tool.
-
Turn the plate (A) forward over the spindle and insert the tool.
-
Install the pins (B) in the brake piston's slot.
-
Turn the spindle (C) so that the plate (A) is pressed against the brake caliper.
-
Turn the shaft (D) to the right and press back the piston and, at the same time, turn on the spindle (C) to the right, so that the plate (A) is in contact
with the brake caliper.
-
Turn back the brake piston completely and remove the tool.
Brake pads rear, installing
Note! The brake pads' beveled edge shall be positioned downward in the brake caliper.
Install the wear indicator (A) on the underside of the inner brake pad. Install the brake pads. Install the brake caliper and install the new lock screw.
Tightening torque 33 Nm.