V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Locate holder 999 9696 MAGNETIC BASE See: Tools and Equipment/999 9696 Magnetic Base and dial gauge 999 9684 DIAL INDICATOR 0-10
MM See: Tools and Equipment/999 9684 Dial Indicator 0-10 mm with a measuring probe (100 mm long).
Locate measuring probe and measure run out over the whole ring.
If run out is more than 0.15 mm, the pulse wheel must be replaced and the drive shaft checked. See Front pulse wheel replacement See: Service and
Repair/Removal and Replacement/Front Pulse Wheel Replacement or Removing/fitting the rear pulse wheel See: Service and Repair/Removal and
Replacement/Removing/Fitting The Rear Pulse Wheel.
Installing front wheel sensor
See Front wheel sensor, replacement See: Service and Repair/Removal and Replacement/Front Wheel Sensor, Replacement.
Rear wheel brakes
Checking clearance in rear wheel bearings
Raise car so that wheels can rotate freely.
Check bearings for play and replace if necessary.
Checking rear wheel pulse wheel visually for lateral runout
Remove
-
hub cap and wheel.
-
brake caliper and brake disc, see Replacement of rear brake disc See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Replacement Of Rear Brake Disc.
Rotate hub slowly and inspect pulse wheel visually for runout.
Check pulse wheel mounting.
Check pulse wheel again for runout.
Check runout in hub.
Replace pulse wheel and/or brake disc hub if there is runout.
Measuring runout in the rear wheel pulse wheel