V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Front Wheel Sensor, Replacement
Preparations
Ignition off.
Remove the hub cap and the wheel.
Removing front wheel sensor
NOTE: Carefully clean the sensor and the connector before they are removed.
Remove the mounting bolt and pull out the sensor.
Remove the two brackets from the inside of the wing.
Pull the sensor cable out of the supports.
Partially remove the plastic inner wing
Disconnect the connector.
Installing front wheel sensor
Clean the sensor seat of dirt and rust so that the sensor is in the correct position relative to the pulse wheel.
Clean dirt from the pulse wheel using compressed air.
Connect the connector and install the two screws to the inside of the wing.
Install the plastic inner wing.
Clean the mounting surfaces so that the sensor can be fitted easily. Lightly grease the sensor.
Install the sensor. Tighten to 25 Nm.
Press the sensor cable into the support.
Install the wheel.
Checking correct operation of ABS system
Read out the DTCs.
Carry out a test-drive and check whether the ABS warning light goes out.
Read out and check whether there are any DTCs stored.
Rear Pulse Wheel
Replacing The Rear Pulse Wheel
