V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Note! Take care to avoid damaging the bell joint and/or pulse wheel.
-
Clean surface.
-
Position the pulse wheel on the drive shaft.
-
Install 999 5694 Socket See: Tools and Equipment/999 5694 Socket and use a drive shaft nut with flange (model year 1998-) to press the pulse
wheel to the end of the drive shaft.
-
Check installation is correct for fit.
Installing drive shaft in knuckle
Check the sealing ring in the knuckle.
Carefully install the shaft in the knuckle.
Install
-
a new retaining nut and ring on the drive shaft.
-
the knuckle in the shock absorber support, using new bolts and nuts. Tightening torque 90 Nm.
Finishing
Turn the steering wheel until it is straight ahead
Install
-
the brake pads, see Replacing front brake pads See: Disc Brake System/Brake Pad/Service and Repair/Removal and Replacement/Replacing Front
Brake Pads.
-
the brake caliper, see operation Front brake disc replacement See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Front Brake Disc Replacement.
-
the brake hose and the sensor cable in the supports.
-
the wheel, see operation Replacing front brake pads See: Disc Brake System/Brake Pad/Service and Repair/Removal and Replacement/Replacing
Front Brake Pads.
-
the drive shaft nut.
-
Tighten with 240 Nm.
-
(From chassis no. 130000, tighten the drive shaft nut with 120 Nm + 60 °.)
-
the wheel cover/cap.
Warning! Always depress the brake pedal several times before driving the car!
Check the brake fluid level.