V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Remove the clamp from the resistor.
If the original resistor was mounted horizontally, the wires should be cut ca. 75 mm (A) from the resistor.
If the original resistor was mounted vertically, the wires should be cut ca. 110 mm (A) from the resistor.
Remove the insulating sleeve.
Strip the ends 7 mm using stripping tool 951 2620.
Twist the ends of the wires.
Connecting the new resistor
4
Caution!
Join the red wires together and the blue wire to the black wire on the new resistor
Twist the ends of the wires. Insert the wires in the splicing sleeves as described above. Press the splicing sleeves to the wires using crimping tool 951
2656. Use opening No. 2.
Pull the wires to ensure a good connection.
Shrinking the splice sleeves
5
Use hot-air gun 951 2850 and nozzle 951 2780.
Set the hot air gun to flow 2 and set the temperature between 2 and 3 (69°C). Protect the surrounding components from heat. Position the splice sleeve in
nozzle 951 2780 and heat the joint so that the adhesive melts and begins to emerge from each end.
