V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Installation Function
Function group 21
Replacing the cylinder head/gasket.
4
Removing the pistons
Note! On later version engines the connecting rod
and the end cap mating surfaces are aligned by a
dedicated fracture surface. Note the markings on the
connecting rod and the end caps and the direction in
which they are installed, forward, rearward, left, right.
On earlier version engines the connecting rod and end cap
mating surfaces are aligned by serrations. NOT all
connecting rods and end caps may be marked as described
above. If markings are in place then note location as
described above. If NO markings exist stamp or etch the
appropriate cylinder number on each all facing the same
direction.
Turn the crankshaft to bottom dead center to access the
two connecting rod cap bolts.
Remove the end cap bolts.
5