V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Install:
-
the ignition coils and ignition cables according to the earlier markings
-
the connectors on the variable valve timing valve and ignition coils
-
the ground lead for the ignition coils
-
the camshaft position (CMP) sensor.
Place the cable duct and cable harness in position.
Install:
-
the screws for the cable duct on the rear edge of the cylinder head and throttle body (TB) bracket
-
the connectors for the injectors
-
the connector for the engine coolant temperature sensor
-
the inlet hose between the mass air flow (MAF) sensor and throttle body (TB)
-
front timing cover
-
the cover over the ignition coils
-
the upper timing cover
-
the cover over the throttle body (TB)
-
the cover over the injectors.
Installing the starter motor
Install the starter motor. See See: Starting and Charging/Starting System/Starter Motor/Service and Repair/Removal and Replacement.
Finishing
Check:
-
the engine oil level
-
the coolant level.
Warm up the engine until the thermostat opens.
Check the engine for leaks.
Top up the coolant if necessary.