V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Disconnect the connections and seal the openings.
-
Clean all contact surfaces.
-
Remove the coupling on the bulkhead
-
Tighten the coupling, holding the pipe with an adjustable wrench (the nut is welded).
-
Carefully pull the pipe out of the clips and remove it.
Fitting The Pipe Between The Coupling And The Refrigerant Reservoir On The Bulkhead
NOTE: Always use new O-rings.
Fit:
-
the pipe clips
-
the O-rings
-
Fit the coupling on the bulkhead.
-
Tighten the coupling, holding the pipe with an adjustable wrench (the nut is welded).
-
Oil O-rings with AC compressor oil
-
Remove the seals.
-
Connect the pipe and tighten the bolts by hand.
Tighten:
-
the bolt at the coupling to 13 Nm.
-
the bolt at the evaporator to 10 Nm.
Pipe between the refrigerant reservoir and the condenser
Removing The Pipe Between The Refrigerant Reservoir And The Condenser