V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Close the bleed nipple and remove the hose.
Tightening torque: 5 Nm.
Install the protective cap.
Slowly fill the brake fluid reservoir.
Slowly depress the brake pedal several times.
Order of replacement
Carry out bleeding/replacement in the following order.
-
Rear right
-
Rear left
-
Front right
-
Front left
Checking the brake system after replacement
Remove the bleeding system.
Check if there is any remaining air in the system by depressing the brake pedal with the same force as when braking normally.
The pedal must not move downwards more than 40 mm when the engine is switched off, and after the brake pedal is depressed 3-4 times. Bleed again if
the pedal's movement exceeds 40 mm.
Check the brake system. Check for leaks.
Check the brake fluid level.
Wipe up any spilled brake fluid.