V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Remove the right front wheel.
Position the upper timing cover.
Turn the crankshaft until the markings on the crankshaft and camshaft pulley correspond.
Turn the crankshaft a further l/4 turn clockwise and then back again until the markings correspond. The markings are illustrated. Remove the upper
timing cover.
Removing the timing belt
Slacken off the center screw for the belt tensioner slightly.
Hold the center screw still. Turn the tensioner eccentric clockwise using a 6 mm Allen key to 10 o'clock.
Remove the timing belt from the tension pulley, camshaft pulley and water pump.
Tensioning the tensioner pulley and the idler pulley
Spin the idler pulley and listen for noise. When replacing with a new idler pulley, tighten to 24 Nm.
Spin the tension pulley and listen for noise. When replacing, screw the tension pulley into place using the center screw.
Screw in the center screw by hand.
Ensure that the tensioner fork is centered over the cylinder block rib.
Ensure that the Allen hole on the eccentric is at "10 o'clock".
Removing the splash guards under the engine
Remove:
