V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Remove:
-
the drive shaft nut
-
the tie rod ball joint. See Ball joint tie rod, protective bellow or tie rod, replacing See: Steering and Suspension/Steering/Tie Rod/Service and
Repair/Removal and Replacement
-
slacken off the wheel spindle nut as much as possible
-
the two wheel spindle screws.
Use a universal puller to withdraw the drive shaft from the wheel spindle. See step Control arm and control arm bushings, replacing, AW55-50/51SN
See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Control Arm And Control Arm Bushings, Replacing.
Remove the nut from the ball joint.
Warning! Secure the tool by tying it into place to prevent damage.
Press out the ball joint. Use special tool 999 5637 Puller See: Tools and Equipment/999 5637 Puller.
Remove the wheel spindle.
Locate the wheel spindle in the special tool
