V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Refer to Photo 3.
^
Install connector A from the service harness to connector E (that was removed from the starter switch).
^
Install connector B from the service harness to the starter switch.
^
Place the service harness in its mounting position and fasten it with the two cable ties to the existing harness. Make sure the routing avoids
potential chafing of the harness.
^
Remove one of the Junction Box upper fixation nuts, and install ground terminal C on the threaded stud. Tightening torque of the fixation nut
4.5 Nm (3.3 lb-ft).
^
Check the resistance to ground through terminal C with an ohmmeter. The resistance shall be less than 1 Ohms.
7.
Test function
^
Switch ignition on.
^
The relay located in relay socket D must switch on with ignition on.
^
Crank engine; engine must start.
^
Check if Immobilizer warning lamp switches off.
^
Switch ignition off; relay located in relay socket D must switch off.
8.
Re-install steering column covers
Refer to VIDA.
9.
Install driver side dashboard soundproofing
Refer to VIDA.
