V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Adjusting the gear-shift position sensor
Remove the nut for the cable duct mounting. Lift the cable duct away from the screw.
Slacken off the screws for the gear-shift position sensor.
Rotate the gear position sensor so that the mark on the switch aligns with the groove on the tool. Tighten the screws for the sensor. Tighten to 25 Nm.
Remove the adjustment tool.
Installation
Installing the lever
Install the cable duct on the screw. Tighten to 25 Nm.
Install the lever on the control shaft.Tighten to 16 Nm.
Install the cable on the lever.
Installing engine compartment components
Note: When installing the battery lead, see Note when disconnecting and connecting the battery lead
Install
-
the battery shelf
-
the air cleaner (ACL) housing, the intake manifold and the battery
