V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Install tool 999 5753 at the rear of the intake camshaft.
Turn the crankshaft in the direction of engine rotation (clockwise) until the marking on the tool (111l/EX3) is opposite the thin flange running straight
over the entire top of the cylinder head.
Remove all plugs from the test holes.
Note: If the crankshaft is turned to far, it is essential that it is turned back at least a quarter of a turn so that it can then be turned clockwise to the
correct position.
Check the valve clearance
Measure the valve clearance using a feeler gauge 999 5752 at cylinder 1 intake valves and cylinder 3 exhaust valves.
Insert the feeler gauge through the inspection holes. Bend the feeler gauge with light finger pressure so that it follows the top of the valve lifter.
The correct measurement will not be obtained until the feeler gauge has gone in approximately 15 mm
Reference values
Note: Carry out this check with the engine at room temperature.
Make a note of the valve clearance on a form.
Next test measurement