V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Remove the transport protection on the new control module
-
Center the control module on the ABS hydraulic modulator valves before the valves are pushed into place
-
Carefully position the control module
-
Install the six Torx screws in the following two stages:
Tighten the screws. Tighten to 3 Nm.
Angle-tighten the screws 90 degree
NOTE: The torque must not exceed 8 Nm.
-
Connect the pump motor connector.
Installing the ABS hydraulic modulator and the control module
-
Carefully lower the control module and ABS hydraulic modulator.
The brake pipes will follow at the same time. Do not damage the brake pipes
-
Install the 3 rubber dampers and the 2 mounting lugs
-
Tighten the 2 mounting nuts. Tighten to 25 Nm (E).
Install:
