V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Clean surface.
-
Position the pulse wheel on the drive shaft.
-
Install 999 5694 and use a drive shaft nut with flange (model year 1998-) to press the pulse wheel to the end of the drive shaft.
-
Check installation is correct for fit.
Installing drive shaft in knuckle
Check the sealing ring in the knuckle.
Carefully install the shaft in the knuckle.
Install
-
a new retaining nut and ring on the drive shaft.
-
the knuckle in the shock absorber support, using new bolts and nuts. Tightening torque 90 Nm.
Finishing
Turn the steering wheel until it is straight ahead
Install
-
the brake pads.
-
the brake caliper.
-
the brake hose and the sensor cable in the supports.
-
the wheel.
-
the drive shaft nut.
-
Tighten with-240 Nm.
-
(From chassis no. 130000, tighten the drive shaft nut with 120 Nm + 60 degrees.)
-
the wheel cover/cap.
WARNING: Always depress the brake pedal several times before driving the car.
Check the brake fluid level.
Checking correct operation of ABS system
Read out the DTCs.
Carry out a test-drive and check whether the ABS warning light goes out.
Read out and check whether there are any DTCs stored.
Front Wheel Sensor