V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Wheels: Procedures
Removing the build up of rust from wheels and hubs
General information
To facilitate the removal of the wheel, the surfaces of the brake disc and hub must be properly cleaned when removing rust. In normal circumstances it is
sufficient to treat the hub according to the instructions for installing the wheel, Installing wheels See: Removal and Replacement.
Cleaning the mounting surfaces of the wheel
-
Brush clean the mounting surfaces marked gray on the brake disc as illustrated and on the inside of the wheel
-
Clean the sections
-
Only apply installation paste P/N 1161397 to the marked gray sections of the brake disc and hub (see the illustration)
-
Install the wheel. See Installing wheels See: Removal and Replacement.