V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Location Of Components (Solenoids)
Note! Readings should be taken at approximately 20°C.
Solenoid SLT, SLS and SLU
Measure the resistance between both the pins in the solenoid connector.
Correct value: 5.0-5.6 ohms.
If the value of any of solenoids SLT, SLS and SLU is incorrect
Replace the control system according to Replacing the control system.
The control system is calibrated together with the solenoids.
Replacing solenoids S1-S5
Location Of Components (Solenoids)
Remove the screw from the solenoid. Remove the solenoid from the control system.
Lubricate the O-ring on the new solenoid. Use automatic transmission fluid.
Install the solenoid. Tighten the screw. Tighten to 7 Nm.
Finishing