volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Procedures|Page 5309 > < Procedures|Page 5307
Page 6
background image

Note! When installing the battery lead, see  Note when disconnecting and connecting the battery lead See: Starting and
Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.

Install:

-

the battery shelf

-

the air cleaner (ACL) housing assembly with the intake pipe

-

see  Replacing the air cleaner (ACL) See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Removal and Replacement 

-

the battery.

Checking diagnostic trouble codes (DTCs)

Check and erase any diagnostic trouble codes (DTCs).

Replacing The Right And Left-Hand Differential Seals

Replacing the right and left-hand differential seals

Special tools:

 999 5768 Puller  See: Tools and Equipment/999 5768 Puller 
 999 5769 Pilot  See: Tools and Equipment/999 5769 Pilot 
 999 5770 Drift  See: Tools and Equipment/999 5770 Drift 
 999 5771 Drift  See: Tools and Equipment/999 5771 Drift 

Left-hand side

Preparatory work

Remove the cross member. Remove the central front-rear member. 
(Applies only to USA) Remove the cross member. Remove the central front-rear member. See  Replacing the cross member, AW55-50/51SN See: Body
and Frame/Frame/Cross-Member/Front Cross-Member/Service and Repair.
Remove the drive shaft according to  Drive shaft left-hand side, replace, AW55-50/51SN See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Drive Shaft Left-Hand Side, Replace.

Procedures|Page 5309 > < Procedures|Page 5307