V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Valve Body: Service and Repair
Replacing the solenoids and control system
Replacing and checking solenoids
Preparations
Remove according to Replacing the cable harness for the control system, AW55-50/51SN See: Wiring Harness/Service and Repair.
Disconnect the connectors from the solenoids.
Check the resistance in S1-S5
Location Of Components (Solenoids)
Note! Readings should be taken at approximately 20°C.
Solenoid S1
Measure the resistance between the pin in the solenoid connector and the transmission ground terminal.
Correct value: 12-16 ohms.
Solenoids S2-S5
Measure the resistance between the pin in the solenoid connector and the transmission ground terminal.
Correct value: 11-15 ohms.
If the resistance of any of solenoids S1-S5 is incorrect
Replace the solenoid according to Replacing solenoids S1-S5.
Checking the resistance of SLT, SLS and SLU
