V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Back Window Glass: Service and Repair
Installing the Rear Windshield
Installing the rear windshield
Special tools:
998 6030 See: Tools and Equipment/998 6030
Preparations
Check the mounting clamps.
Install new spacers.
Dimension A = 50 mm.
Dimension B = 230 mm.
Dimension C = 230 mm.
Install suction pads 998 6030 See: Tools and Equipment/998 6030
Place the window on a stand.
Install the trim strip at the top edge.
Install strips of tape vertically on the bodywork to secure the window position when installing.
Windshield installation
Apply PUR adhesive according to Installing windshields See: Windshield/Service and Repair.
Fold back the cable connectors for the heated rear windshield.
Position the windshield.
Secure the strips of tape to the window.
Push the window down by hand if any further height adjustment is required.
Make sure that the rubber seal is positioned firmly against the body.
Leak test!
Note! Allow the adhesive to cure so that the window does not change position before installing the components.
Installing components