V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Mark the position of the control arm position on the mounting plate.
-
Remove the control arm mounting nut (A).
-
Remove the wiper motor 3 x mounting screws (B).
Installing the windshield wiper motor
-
Apply grease 1161037-5, on the inside of the rubber.
-
Install the wiper motor and tighten the mounting screw (3x).
-
Connect the connector.
Hint: Activate the wiper motor once. Check that the motor stopped in the parked position.
-
Install the control arm according to the markings.
-
Tighten the nut to 20 Nm. Use a 20 mm U-wrench to secure the control arm when the nut is pulled out.
-
Check the wiper motor function by rotating it a number of times.
-
Press the drive mechanism ball into position using a large screwdriver and reinstall the motor with the mounting plate, 4 x mounting screws.
-
Install the cover.
Replacing the windshield wiper shaft and/or the link rod