V50 L5-2.4L VIN 38 B5244S4 (2006)
-
Grip the upper edge of the right-hand side cushion and pull forward so that the two catches (A) release.
-
Move your hand to the side of the side cushion and release the catch located in the lower edge.
-
Slide the side cushion upwards.
-
Remove the screw at the rear edge of the panel at the front/top of the right-hand side panel (B).
-
Pull the panel upwards so that the four clips on the inside release.
-
Fold out the load securing eyelets on the right-hand side panel. Insert a scriber with an angled tip into the holes in the top of the covers (1). Turn
the scriber so that the tip engages the reverse of the covers. Pull the covers off.
-
Remove the screws in the load securing eyelets.
-
Remove the screw (2) at the front/top edge of the side panel.
-
Pull off the side panel at the top so that the two clips at the rear/bottom of the side window and the clip at the bottom of the D-post release. If the
car has a 12V socket in the side panel, disconnect the connector from this socket.
-
Lift out the side panel.
-
Remove the insulation panel on the right-hand side. The insulation panel is secured by two clips behind the rear wheel arch.
Applies to the S40
