V50 L5-2.4L VIN 38 B5244S4 (2006)
Illustration A
-
Take the cable harness with rubber grommet from the kit. The cable harness has a taped rubber grommet with integrated cable for keyless cars.
-
Pull in the end with four connectors through the hole in the car and fit the rubber grommet.
-
Fit the connector (1) for the sensors in the designated location below the rear lamp. Make sure that the clip engages properly.
Illustration B
-
Cut off the free rubber spout on the cable harness rubber grommet.
-
Thread through the towbar wiring cables. Lubricate the coarse cable with something not harmful to the rubber grommet and pull the cable through
the hole.
Illustration C. Cable installation
-
Fit the cable with the clips.
-
Applies to keyless cars: Attach the connector to the antenna, Keyless Vehicle Module (KVM).
-
Applies to others: Attach the connector with a tie strap so that it does not rattle.
