V50 L5-2.4L VIN 38 B5244S4 (2006)
-
Unhook the bracket from the amplifier
-
Remove the three connectors from the bottom of the amplifier. Place the amplifier to one side. It will not be used again
-
Install the bracket with the GPS antenna on the new amplifier. Tighten the bracket using the existing screw
-
Connect the connectors on the bottom of the amplifier
-
Install the amplifier on the studs
-
Install and tighten the three nuts. Tighten to 10 Nm (7.5 lbf. ft.)
-
Install the insulation around the amplifier.
Reinstall:
-
the side panel. Tighten using the screw at the front edge. Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf. ft.)
-
the lower panel on the C-post
-
the rubber strip at the rear edge of the opening for the rear door
-
the panel at the front/top of the side panel. Press downwards so that the catches engage. Tighten using the screw
-
the side cushion
-
the rubber strip in the boot lid opening
-
the sill trim panel for the boot lid.
-
Reinstall the cargo compartment carpet
-
Fold the backrest and seat back into place.
-
Turn the ignition key to position II
-
Reconnect the battery negative lead
-
Go to point 24.
Points 15-23 apply to S40 (04-)
-
Remove the cargo compartment carpet.