V50 L5-2.4L VIN 38 B5244S4 (2006)
Illustration B applies to the V50
-
Press the connected connector into the trailer module (TRM).
-
Connect the ground lead from the routed cable harness to the ground terminal under the tail lamp. Tighten the screw fully.
Applies to the V50
-
Reinstall the AM/FM tuner module (AFM) / traffic message channel module (TMC).
-
Reinstall the insulation panel.
Applies to the S40 (04-)/V50
-
Refit the back-up (reversing) warning system (PAS), if the car is equipped with one. Refit any other detached cables.
-
Reinstall the side panel. If the car has a 12V socket, connect the connector to this.
Applies to the V50
-
Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf.ft.).
-
Reinstall the panel at the front/top of the side panel. Press downwards so that the catches engage. Tighten using the screw.
-
Reinstall the C-post panel.
-
Reinstall the rubber strip at the rear edge of the opening for the rear door.
-
Reinstall the side bolster.
Applies to the S40 (04-)/V50
-
Reinstall the rubber strip in the tailgate opening.
-
Reinstall the sill trim panel in the tailgate opening.
Applies to S40 (04-)
-
Reinstall the upper floor supports if applicable.
Applies to the S40 (04-)/V50
-
Reinstall the cargo compartment carpet.
Applies to the V50
-
Fold the backrest and seat back into place.
Applies to the S40 (04-)/V50