V50 L5-2.4L VIN 38 B5244S4 (2006)
-
Remove the remaining protective backing tape from the Velcro fasteners.
-
Connect the connector from the wiring to the control module.
-
Press the control module on the rear display screen in such a way that the wiring connector is not located at the edge of the lower edge of the
display screen.
Illustration A
-
Look for the pre-routed 2-pin gray connector (1) for the control module power supply, and the pre-routed 5-pin green connector (2) for signals to
the control module. The connectors are clamped at the front edge of the large hole in the side of the bodywork.
Note! If the car is equipped with an Accessory Electronic Module (AEM) then the green connector is not clamped but hangs loose.
-
Connect the connectors to the control module.
-
Reinstall the AM/FM tuner module (AFM) / traffic message channel module (TMC).
Illustration B
