V50 L5-2.4L VIN 38 B5244S4 (2006)
CAUTION: The heater pad must be correctly positioned so that when the half moon clips are secured they are not too close to the heating
loops or the surface of the heater pad.
Position the heater pad in the correct position. Do not remove the backing from the adhesive surfaces.
Secure one half of the heater pad. Fold up the other half. Pull the backing (or part of the backing) off the adhesive surface closest to the center of the
section of the heater pad that is bent up.
Carefully bring the adhesive surface down onto the foam filling. Work with small sections at a time. Start from the center and work out towards the
edges.
Continue in the same way with the other adhesive surfaces.
If the heater pad terminates at the channel, position it as illustrated.
NOTE: The end of the pad must not be up on the flat surface.
