V50 L5-2.4L VIN 38 B5244S4 (2006)
Applies to the V50 with mini-spoilers on the rear window
-
Remove the spoilers from the rear window using a weatherstrip tool, they are secured with double-sided adhesive tape.
Take care not to scratch the window.
-
Clean the rear window of tape residue.
Applies to all models
-
Clean the mating surfaces of the spoiler against the tailgate. Use a mixture of 30% windscreen washer fluid and 70% water. Wipe dry.
-
Take the tape from the kit. Remove the thin backing tape. Press the tape firmly into place on the mating surfaces. Allow the thicker backing tape to
remain in place.
-
Take the tape washers from the kit. Remove the thin backing tape. Allow the thicker backing tape to remain in place.
-
Press the tape properly into place on the projections on the spoiler where the studs are attached.
Spray paint according to the "Touch up spraying" service instructions.
Note! The tape must cure for 24 hours at a minimum of 20°C before painting.
-
Remove the outer section of the inner handle for the tailgate. First pry off the handle at the sides of the joint between both sections. Then pull
straight out. The inner section releases with the panel when removed.
