V50 L5-2.4L VIN 38 B5244S4 (2006)
Brake Pad: Service and Repair
Brake Pads Front
Brake pads, front
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Remove the wheels on both sides.
Removing the brake pads
Note! Minimum thickness for replacing brake pads = 2 mm.
Remove:
-
the spring
-
the protective caps
-
the locating pins, use a 7 mm hex socket
-
the brake caliper. Hang up the caliper in a suitable position to avoid damaging the brake hose
-
the brake pads.
Note! Do not depress the brake pedal while the brake pads are removed.
Cleaning the brake caliper
Clean and check the brake caliper and dust cover.
Clean and check the brake pad mating surfaces in the brake caliper and caliper holder.
Clean the sliding pins using a steel brush.
Note! If the dust boot is damaged dirt may have penetrated the cylinder. If this is the case the caliper must be replaced.
Brake disc check
