V50 L5-2.4L VIN 38 B5244S4 (2006)
Climate Control Exhaust Gas Sensor: Service and Repair
Air Quality Sensor
Air quality sensor
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Ignition off and removing the glove compartment
Ignition off.
Remove the glove compartment. See: Glove compartment See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Glove
Compartment.
Removal
Removing the air quality sensor (AQS)
The air quality sensor (AQS) is located in front of the damper motor module (DMM) recirculation.
Turn the air quality sensor (AQS) approximately 60 degrees counter-clockwise.
Disconnect the connector.
Installation
Installing the air quality sensor (AQS)
Connect the connector.
Position the air quality sensor (AQS) in the groove. Turn the air quality sensor (AQS) approximately 60 degrees clockwise until it stops.
Check that it is secure.
Install the glove compartment. See: Glove compartment See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Glove
Compartment.
Finishing
