V50 L5-2.4L VIN 38 B5244S4 (2006)
V50 right side:
On the V50, the washer hose to the rear windshield goes through a rubber grommet. Add insulating tape P/N 9511072 around the hose and
grommet (see step 8).
Secure the excess harness length in the connector housing with cable ties.
Photo is of right side passenger compartment. Left side compartment is not equipped with connectors. Store excess harness in the same general
area when working on the left side.
Splices left visible for illustration only
Method For Splicing Door Harness A-Pillar Connector
Service Method for Splicing Door Harness A-pillar Connector
This operation may be done with the door on the bench if desired. Be careful in order to not cause any damage to the door (dents, paint nicks, etc)
as it is placed on the bench.
11.
Remove the loudspeaker, front door, see VIDA: Removal, replacement and installation> Electrical system > Media, communication and
navigation>
Radio equipment
12.
Remove the connector from the door
13.
Cut the cable tie.
