V50 L5-2.4L VIN 38 B5244S4 (2006)
6.
Remove the grommet so that the connector is released.
Feed the grommet past the harness into the A-pillar cavity to expose as much of the harness bundle as possible. See photo sequence above.
7.
Only applies to V50, right side
On the V50, the washer hose to the rear windshield goes through a rubber grommet.
Remove the insulating tape so that the hose can run freely through the rubber grommet.
Use soap solution or similar to lubricate the hose.
8.
Splicing of the repair connector into the car harness
