V50 L5-2.4L VIN 38 B5244S4 (2006)
Removing the upper panel on the C-post:
-
This is removed in the same way as the lower panel (C) on the C-post. However there are three clips which must release.
Removing the side panel:
-
Fold out the load securing eyelets on the right-hand side panel
-
Insert a scriber with an angled tip into the holes in the top of the covers (1). Turn the scriber so that the tip engages the reverse of the cover. Pull
the cover off
-
Remove the screws in the load securing eyelets
-
Remove the screw (2) at the front/top edge of the side panel
-
Pull off the side panel at the top so that the two clips at the rear/bottom of the side window and the clip at the bottom of the D-post release
-
Lift out the side panel.
Removing the panel from the D-post:
-
Carefully pry of the right-hand D-post panel at the bottom edge. Use a plastic weatherstrip tool
-
Pull the D-post panel forwards so that the two clips at the bottom release. Then continue pulling forwards until the two higher clips release
-
Unhook the D-post panel backwards from the headlining.
Note! Do not damage the panels.
