V50 L5-2.4L VIN 38 B5244S4 (2006)
Note! The end of the clamp equipped with cut-outs must be turned towards the lower edge of the gear selector lever knob. The two vertical
cut-outs (1) in the clamp must fit into the corresponding ridges (2) in the lower section of the knob.
-
Take the clamp from the kit and guide it onto the lower section of the gear selector lever knob, press it against the lower section of the knob and
snap it closed. Check that the gaiter is firmly attached and that the clamp has snapped shut properly.
-
Turn the inside of the gear selector lever gaiter back in.
-
Press the gear selector lever knob onto the gear selector lever and check that it is firmly attached.
-
Fit the gaiter in the centre console starting with the rear end.
Gear Selector Lever Knob, Leather
Gear selector lever knob, leather
INTRODUCTION
-
NOTE! Read through the whole installation instruction before starting the work.
-
The front page gives the date of this edition and the edition it replaces
-
The second page shows the tools needed for the installation and the contents of the installation kit
-
The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
-
Cut out the text page in order to follow the illustrations and text at the same time.
Gear selector lever knob
Applies to manual gearboxes
