V50 L5-2.4L VIN 38 B5244S4 (2006)
-
Pull the gear selector lever knob away from the gaiter.
-
Guide the gear selector lever knob inside the out-turned gear selector lever gaiter. The text on the gear selector lever knob must point from the
seam in the gaiter.
-
Thread the gaiter onto the lower section of the knob maintaining the position of the gaiter and knob.
-
The lower section of the knob must be edge to edge with the small opening of the gaiter (see inset illustration).
Note! The end of the clamp equipped with cut-outs must be turned towards the lower edge of the gear selector lever knob. The two vertical
cut-outs (1) in the clamp must fit into the corresponding ridges (2) in the lower section of the knob.
-
Take the clamp and guide it onto the lower section of the gear selector lever knob, press it against the lower section of the knob and snap it closed.
-
Check that the gaiter is firmly attached and that the clamp has snapped shut properly.
