V50 L5-2.4L VIN 38 B5244S4 (2006)
Note! Leave the container in place for the next few procedures relating to removal.
Note the quantity of oil collected.
Note! The collected oil must not be reused.
Drain the transmission oil.
Tighten the plug. See: Tightening torque See: Specifications/Mechanical Specifications/Tightening Torque.
Removing components from the transmission
Remove the oil line from the transmission and the oil cooler.
Hint: The quick-release connector for the oil cooler is detached by pressing the connection housing for the oil line towards the oil cooler. Hold the
connection housing in this position. Pull back the lugs on the connection housing. Pull the connector off the oil cooler.
Seal the hole in the transmission with a plastic plug.
Removing screws
Remove all screws for the control system cover. Leave the cover in place.
Clean any sealing compound from the threads. Use tap M8x1.25.
Removing the cover for the control system
