V50 L5-2.4L VIN 38 B5244S4 (2006)
-
Take the gear selector lever gaiter from the kit and turn it inside out.
-
Guide the gear selector lever knob inside the out-turned gear selector lever gaiter. The text on the gear selector lever knob must point towards the
two seams in the lower section of the gaiter.
-
Thread the gaiter onto the lower section of the knob maintaining the position of the gaiter and knob.
-
The lower section of the knob must be edge to edge with the small opening of the gaiter (see inset illustration).
Note! The end of the clamp equipped with cut-outs must be turned towards the lower edge of the gear selector lever knob. The two vertical
cut-outs (1) in the clamp must fit into the corresponding ridges (2) in the lower section of the knob.
-
Take the clamp from the kit and guide it onto the lower section of the gear selector lever knob, press it against the lower section of the knob and
snap it closed. Check that the gaiter is firmly attached and that the clamp has snapped shut properly.
