V50 L5-2.4L VIN 39 B5244S7 (2005)
Note! To ensure the best results, it is recommended that two people press the new antenna onto the roof. One person should push against the
inside of the roof to prevent buckling when the antenna is pressed down.
-
Clean the area on the roof where the new antenna is to be positioned. Use a mixture of 30% isopropanol and 70% water. Wipe dry
-
Remove the protective film from the tape on the antenna
-
Align the locating pins for the antenna in the corresponding holes in the roof. Press the antenna securely into place.
Note! Apply pressure to the antenna for at least 30 seconds so that the tape secures properly.
-
Turn the clip 90°. Remove the clip from the headlining
-
Carefully fold down the centre section of the rear end of the headlining. Find the pre-routed cable for the antenna behind the hole for the interior
lighting.
-
Connect the violet connector on the pre-routed antenna cable to the left outlet on the antenna. The antenna cable is taped to the headlining behind
the hole for the interior lighting
-
Reinstall the clip in the headlining
-
Reinstall the interior lighting.
Caution! Leave the car indoors for two hours after installing the antenna. Do not wash the car for at least 48 hours after installation.
