V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Connect the connector from the wiring to the control module.
-
Press the control module on the rear display screen in such a way that the wiring connector is not located at the edge of the lower edge of the
display screen. Also check that the module's rear edge is not too close to the body edge.
Illustration A
-
Look for the pre-routed 2-pin gray connector (1) for the control module power supply, and the pre-routed 5-pin green connector (2) for signals to
the control module. The connectors are clamped at the front edge of the large hole in the side of the bodywork.
Note! If the car is equipped with an Accessory Electronic Module (AEM) then the green connector is not clamped but hangs loose.
-
Connect the connectors to the control module.
Illustration B
Applies to cars from CH 45000-, with Parking Assistance Module (PAM)
-
Detach the green (GN) five pin connector (1) which is taped at the Parking Assistance Module (PAM) cable's rubber grommet.
-
Plug the green connector into the Trailer module wiring, (TRM).
