V50 L5-2.4L VIN 39 B5244S7 (2005)
Applies to Installation Instructions 8682349
-
Take the towing ball holder and mounting, two M14x110 flanged screws and two flange nuts from the kit
-
Install the holder on the L-profile together with the bracket and the electrical connector. Ensure that the bracket is on the left-hand side of the
holder and that its front edge (1) is parallel with the front edge of the holder (2).
Note! Do not tighten fully yet.
-
Take six flanged screws, washers and the reinforcement strut from the kit. Install the brackets for the reinforcement strut on the underneath of the
side members. Use screws and washers. The collision plate (if present) is reinstalled outermost on the right-hand side.
Note! Do not tighten fully yet.
-
Take four M10x25 screws from the kit. Install the other end of the reinforcement strut on the reverse of the panel flange, in the lower edge of the
car body
-
Alternately tighten the four M10 screws for the L-profile, so that the L-profile is correctly positioned against both sides of the collision member
Tighten to 47 Nm (35 lbf. ft.)
-
Tighten the four M10 screws in the panel flange at the bottom edge of the car body. Tighten to 47 Nm (35 lbf. ft.)
-
Tighten the two M14 screws through the spacer pipe. Tighten to 200 Nm (147 lbf. ft.)
-
Tighten the screws in the new brackets for the rear silencer mountings. Tighten to 30 Nm (22 lbf. ft.). There is limited space to torque tighten the
centre screw (1) in the new brackets, use socket P/N 9814011 with a 3/8" socket extension
-
Reinstall the rubber mountings on the brackets.
-
Continue to point 7 in the Installation Instructions for the tow hitch.
